Flashforge Inventor User Manual page 16

（ ）
3. 3-3 Lift the Inventor by its side openings and place it on a flat surface. Then
You will see the Expert
Expert Kit, you can find a Carving Knife, a Scraper, Tweezers, a Sensor line
a Screw Box. What's more.
4.（3-4）The Inventor will have an accessory box on top of it, which will house the
extruder set. Remove the box and the foam pad from the Inventor, and gently lay the
extruder set on the Inventor build plate.
Inside the accessory box, you will find an
of removable side panels.
5. (3-5) Move the build plate up carefully.
Inventor User Guide | www.flashforge.com
Kit, power cord, and
a SD card and some
3-3
SD
3-4
16
USB cable in the shipping box.
screws, Wrenches
card, a side fan duct, and
0086‐ 0579‐82273989
In the
and
in the Box.
two pieces