Flashforge Inventor User Manual page 28

5. （5-5）Press [ NEXT ]
6. （5-6）Press [ NEXT
the paper through to make sure there is a slight friction. Slowly adjust all the screws
by the same amount if there is no friction or too much friction.
7. （5-7）Press [ FINISH ]
Inventor User Guide | www.flashforge.com
again and repeat the same leveling technique.
5-6
]. The nozzle will move to the center of the build plate. Slide
5-7
once you have finished this.
28
0086‐ 0579‐82273989
25