Installing A Sata Hard Drive - Nexcom VTC 6100 User Manual

Chapter 3: System Setup

Installing a SATA Hard Drive

1. The metal bracket is used to hold a SATA hard drive. First, remove the
screws that secure the metal bracket to the board then remove the
bracket.
If you intend to install a CompactFlash card or a Mini PCI Express
module, please install these devices first before proceeding to the
next step. Refer to their respective sections in this chapter for in-
structions on installing a CF card or a Mini PCI Express module.
Copyright © 2009 NEXCOM International Co., Ltd. All Rights Reserved.
• During Windows XP OS installation, press "F6" to select and
install the SATA driver.
• If you intend to install a Windows XP SP2 or earlier version, you
must first set the "USB 2.0 Controller" field (in the BIOS) to
Disabled.
• By default, the "Legacy USB Support" field (in the BIOS) is
Disabled. If you are using a USB device to install the Windows
operating system, you must first set this field to Enabled. Set this
field back to Disabled after you have finished the installation.
2. Position the HDD brackets on each side of the SATA drive. Align the
mounting holes that are on the sides of the SATA drive with the HDD
Metal
brackets' mounting screws.
bracket
Mounting
screws
51
HDD bracket
SATA drive
Mounting
screws
VTC 6100 User Manual