Table of Contents
Advertisement
Appendix C: 8-inch Pendant-mount Housing Installation
50
Step 7)
Remove the three hex nuts that hold the pendant housing to the mounting flange.
When installing the pendant housing with the W option, remove the triangular
stiffener plate (see Figure 71).
Step 8)
Guide the housing and flange assembly through the mating holes in the wall
bracket and reinstall the three hex nuts on the studs (refer to Figure 71). Using a
3/8-inch nut driver or socket wrench, securely tighten the three mounting nuts on
top of the housing to a torque of 3 to 5 ft-lb.
CAUTION!
The KTA-02-12 Wall-mount Bracket is not waterproof, but allows water to drain away before it
reaches the housing lip. DO NOT seal the wall bracket—this will prevent proper drainage.
Figure 71: Attaching the Housing to the Wall Bracket
Step 9)
Prepare the cables as shown in Figure 72.
Figure 72: Preparing the Cables
CyberDome Series Installation Manual
A06-8SG0/B/April2006/1033921C
Advertisement
Table of Contents
