GE CyberDome Series Installation Manual page 26

Cyberdome series

Table of Contents

Housing Installation

CAUTION!

DO NOT connect the 24VAC power cable to the video or RS422 connection in step 4 (below), or the

CyberDome will be damaged.

Step 4)

Make the cable connections to the interface module. See Figure 39. Allow ap-

proximately 3 inches (7.62 cm) of cable for connections.

There are two versions of the CyberDome interface module depending on whether

video is being sent via coaxial cable (CyberDome Coaxial Interface Module) or

unshielded twisted-pair wire (CyberDome UTP Interface Module).

NOTE: When using the CyberDome UTP Interface Module, the unshielded twisted-

pair video and RS422 control wires can share the same wire jacket, but must remain

as separate twisted pairs.

Figure 39: Pipe Connections to Either CyberDome Interface Module

Step 5)

If the housing is being installed

outdoors, install the water-seal-

ing rubber boot (Figure 40):

a) Spray soapy water onto the

pipe.

b) Slide the rubber boot up the

pipe.

c) Apply Teflon tape to the pipe

threads.

NOTE: Teflon tape must be ap-

plied as the first layer of pro-

tection.

CyberDome Series Installation Manual

Figure 40: Water-sealing Rubber Boot

A06-8SG0/B/April2006/1033921C

Table of Contents