Kta-24 Power Supply - GE CyberDome Series Installation Manual

Appendix A: Accessory Installation
38
KTP-24 Power Supply
The KTP-24 (formerly KTA-04-12) is a 24VAC outdoor power supply designed for use with a
pendant-mount weatherproof CyberDome. It provides enough power (100VA) to operate the
dome's pan/tilt drive, camera, and heater/fan. The KTP-24 can be attached directly to a wall,
or it can be mounted on to either the KTA-25/KTA-25W Corner-mount Bracket or the KTA-26/
KTA-26W Pole-mount Bracket. Fasteners are provided for all applications.
Step 1) Loosen the unit's four watertight screws and remove the cover.
Step 2) When attaching the KTP-24 to
a KTA-25/KTA-25W or KTA-26/
KTA-26W, proceed to step 4.
When attaching it directly to a
wall, mark the location of the four
mounting holes using the dimen-
sions shown in Figure 55.
Step 3) Prepare the four mounting holes
in accordance with the type of
wall (e.g., concrete, wood) and
fasteners.
Step 4) Mount the KTP-24 with the ap-
propriate fasteners directly to the
wall, or to the KTA-25/KTA-25W
or KTA-26/KTA-26W brackets
(as shown in Figure 56).
Figure 56: Mounting the KTP-24 to the Corner- and Pole-mount Brackets
Step 5) Make the cable connections as shown in Figure 57.
Figure 57: KTP-24 Cable Connections
Step 6) Replace the cover and tighten the screws securely to ensure a watertight seal.
CyberDome Series Installation Manual
Figure 55: KTP-24 Cover and Mounting Holes
A06-8SG0/B/April2006/1033921C