Table of Contents
Advertisement
Housing Installation
28
Heavy-duty Housing (CyberDome HD) Installation
The CyberDome HD is enclosed in a tamper-resistant aluminum housing with an impact-
resistant acrylic dome. Attached to the housing is a reinforced swivel-mount bracket. It is
designed to mount against a hard surface, but will also mate with a KTA-25/KTA-25W Corner-
mount Bracket or a KTA-26/KTA-26W Pole-mount Bracket. For instructions on using the
corner- or pole-mount brackets, refer to Appendix A: Accessory Installation.
CAUTION!
DO NOT provide power to the housing until all installation steps are complete.
To install and mount the CyberDome HD directly to a hard surface (such as concrete), pro-
ceed with the following steps:
Step 1)
Locate the carriage bolts that secure the upper housing to the swivel-mount
bracket. See Figure 42. Loosen and remove the ESNA nuts (inside the upper
housing), remove the carriage bolts, and detach the upper housing.
Figure 42: Removing the Carriage Bolts
CAUTION!
DO NOT mount the heavy-duty CyberDome HD via the small mounting holes alone. They are for
additional security where needed.
Step 2)
Using the swivel-mount bracket as a template, mark the mounting surface where
the CyberDome HD is to be installed. See Figure 43. Mark the four large mount-
ing slots. For additional security, also mark the four small mounting holes.
Step 3)
Drill the four (or eight) holes into the mounting surface.
CyberDome Series Installation Manual
A06-8SG0/B/April2006/1033921C
Advertisement
Table of Contents
