Table of Contents
Advertisement
CyberDome Series Installation Manual
A06-8SG0/B/April2006/1033921C
7-inch Pendant-mount Housing Installation
The 7-inch pendant housing can be mounted using one of three methods:
•
Method 1 – Suspended from the KTA-20/KTA-20T CyberMount
•
Method 2 – Suspended from the KTA-21/KTA-21W Swing Mount
•
Method 3 – Suspended from a 1.25 in. pipe
Method 1: CyberMount Installation
The KTA-20/KTA-20T CyberMount suspends the CyberDome from a vertical surface.
It can be attached directly to the vertical surface or mated with a KTA-25/KTA-25W Corner-
mount Bracket, a KTA-26/KTA-26W Pole-mount Bracket, or a KTA-27/KTA-27W Roof-mount
Bracket. It provides the path for the video, 24VAC, and RS422 data control cables. For instruc-
tions on installing the corner-, pole- or roof-mount brackets, refer to Appendix A: Accessory
Installation.
To install the 7-inch pendant housing with the CyberMount, proceed as follows.
CAUTION!
DO NOT provide power to the housing until all installation steps are complete.
First, mount the CyberMount to a vertical surface:
Step 1)
If a 1/2 in. (1.27 cm) conduit needs to enter the side of the CyberMount, com-
plete the steps in the KTA-20/KTA-20T CyberMount (Side Conduit Entry) section
of Appendix A: Accessory Installation.
Step 2)
Loosen the two CyberMount cover screws enough to remove the cover (removing
the screws is not necessary). See Figure 20.
Step 3)
Remove the CyberMount cover and interface module. See Figure 20.
Step 4)
Place the CyberMount against the vertical mounting surface, ensure that it is
level, and then mark the location of the four mounting holes and the center cable-
entry opening. See Figure 21.
Figure 20. Removing the Cover and Interface
Module of the CyberMount
(page 17)
(page 21)
(page 25)
Figure 21. Marking the Mounting Holes
Housing Installation
17
Advertisement
Table of Contents
