Table of Contents
Advertisement
Appendix A: Accessory Installation
40
KTA-27/KTA-27W Roof-mount Adapter
The KTA-27/KTA-27W Roof-mount Adapter (formerly KTA-09-12) is designed to combine with
the KTA-02-12W Wall-mount Bracket or KTA-20/KTA-20T CyberMount on the roof or parapet
of a building. The Roof-mount Adapter is hinged to allow the CyberDome to pivot over the roof
for safe servicing.
Step 1)
Remove the cover screw from the top of the KTA-27/KTA-27W and open the
bracket. See Figure 59.
Step 2)
Locate the six mounting slots on the base of the bracket. See Figures 59 and 60.
Step 3)
Place the Roof-mount Adapter on the edge of the roof or parapet, and mark the
location of the mounting slots. See Figures 59 and 60.
Step 4)
Prepare the mounting slots in accordance with the type of wall (e.g., concrete,
wood) and fasteners used.
CAUTION!
For safety, the hardware and procedure used for securing the KTA-27/27W must allow it to support
a minimum of a 35 lb (15.88 kg) load.
Step 5)
Secure the adapter to the roof or parapet with the appropriate fasteners.
Step 6)
Properly seal all mounting holes that could cause leaks into the roof structure.
Figure 59. Roof-mount Adapter Installation
Figure 60. Base of Roof-mount Adapter
CyberDome Series Installation Manual
A06-8SG0/B/April2006/1033921C
Advertisement
Table of Contents
