GE CyberDome Series Installation Manual page 22

Housing Installation
22
Step 2) Place the mounting plate against
the vertical mounting surface,
level the plate, and then mark
the location of the four corner
mounting holes. (Use all six
mounting holes for extra support,
as needed.) See Figure 30.
Step 3) Prepare the mounting holes in
accordance with the type of sur-
face (concrete, wood, etc.) and
fasteners used.
NOTE: Mounting fasteners are not
included.
CAUTION!
For safety, the hardware and procedure used
for securing the top plate must allow it to sup-
port a minimum of a 35 lb (15.88 kg) load.
Step 4) Attach the mounting plate to the vertical mounting surface with the appropriate
fasteners. Make sure the plate is oriented such that the socket is up and the
junction box is down. See Figure 31.
Step 5) Properly seal all mounting holes that could cause leaks into the mounting sur-
face.
Step 6) Slide the swing arm into the
mounting socket and securely
tighten the pivot locking screws.
See Figure 32. Position the arm
such that the collar is accessible
from the rooftop for mounting the
dome.
The swing arm comes with the
cable assembly installed and
tacked down at both ends of the
arm. You may have to untack
the end going through the mount-
ing socket.
CyberDome Series Installation Manual
Figure 30. Marking Mounting Holes
Figure 31. Minimum Load Requirement of Swing
Mount
Figure 32. Placing the Swing Arm in the Mounting
Socket
A06-8SG0/B/April2006/1033921C