Setting Dtcs Polarity - Icom ic-80fx Instruction Manual

D Setting DTCS polarity
For DTCS operation, the polarity setting is configurable, as
well as the code setting. If the polarity is different, the DTCS
squelch never opens, even when receiving a signal that in-
cludes a matching DTCS code.
q Push [FUNC](M), and then [SET](8) to enter the Set mode.
w Push [ ] or [ ] to select the DTCS polarity item (dtP).
e Rotate [VOL] to select a polarity setting between "dtP.nn"
, "dtP.nR"
(TX and RX normal)
Rn"
(TX: reverse, RX: normal)
.
verse)
TX and RX: Normal polarity
TX: Reverse, RX: Normal
r Push [# ENT](MN.W) to exit the Set mode.
, "dtP.
(TX: normal, RX: reverse)
and "dtP.RR"
(TX and RX re-
TX: Normal, RX: Reverse
TX/RX: Reverse polarity
TONE SQUELCH AND POCKET BEEP
D Operation
q Select an operating channel. (p. 15)
w Push [FUNC](M), and then [TONE](1) to set a CTCSS
tone or a DTCS code.
• Repeat step w several times to activate the desired Tone function.
: Push , and then
Subaudible tone encoder
Tone squelch with
pocket beep
Tone squelch
e Operate the transceiver in a normal way. (p. 15)
NOTE: The Tone function is automatically turned OFF if
you change the operating channel.
.
Function OFF
DTCS squelch
DTCS squelch with
pocket beep
(continued on the next page.)
6
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
22