Icom ic-80fx Instruction Manual page 35

D Scan resume setting
Selects the scan resume setting between SCt. 5, SCt. 10,
SCt. 15, and SCP. 2.
When a signal is received during a scan, the scan pauses
and then resumes, according to the scan resume setting.
• SCt. 5/10/15 : The scan pauses for 5, 10 or 15 seconds, and then
resumes.
• SCP.2 : The scan pauses until the received signal disap-
pears, and then resumes after 2 seconds.
D Function key timer
Push [FUNC](M) to enter the Function mode, and then push
a keypad key to activate its second function.
• During the Function mode, "
Sets the time between when the Function mode is entered,
and how long it remains activated after you push the keypad
key to activate its second function.
• F0.At : Exit the Function mode immediately after a key is
pushed to activate its second function.
• F1/2/3.At : The Function mode remains activated for 1, 2 or 3 sec-
onds after a key is pushed to activate its second function.
• F .m : The Function mode remains activated until [FUNC](M)
is pushed again, even after a key is pushed to activate
its second function.
" is displayed on the LCD.
D LCD backlight
Selects the LCD Backlight function.
• LIG.OF : Turns OFF the Backlight function.
• LIG.ON : Lights continuously while the transceiver is ON.
• LIG.At : Turns ON when an operation occurs, and turns OFF
seconds.
after 5
D VOX gain
Sets the VOX gain to between 1 and 10. Higher values make
the VOX function more sensitive to your voice.
To turn OFF the VOX function, select "VOX.OF."
NOTE: Set the microphone gain before setting the VOX
gain. See page 41 for details of the VOX function.
8
SET MODES
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
30