Product Specific Instructions - Manual Wheelchairs; Avantgarde T - Otto Bock LISA 2005 Using Manual

7 Product Specific Instructions – Manual Wheelchairs
– Avantgarde T –
For assembly of the 481S00=SK029 fixation kit you will need the following tools:
ring wrenches sizes 10 and 13, Allen wrenches sizes 4 and 5
Attaching the anchoring points to the product
Mount anchoring points to the front
frame on either side of the unit, just
behind the castor heads, so the fixing
eyelets are facing outwards.
Assembly tip: Important – Only attach the anchor plates to the frame at the indicated points, using the pipe
clips/half-shells and screws provided. Do not fully tighten the screws until the pipe clips/half-shells and anchoring
plates have been positioned correctly.
Unfortunately, the fixation kits cannot be used with all equipment and accessories combinations. For
existing restrictions in the combination of equipment and accessories please refer to the 647F201
Info Sheet.
Guidance for fitting the Pelvic Belt
Avantgarde T showing the correct
positioning of the tie-down straps.
This wheelchair might be equipped with back angle adjustment. Before starting adjust the backrest
to almost upright position and check if the locking mechanism on either side has engaged. Observe
the specifications in the Instructions for Use Manual of the wheelchair.
60
Mount anchor plates to the inner sides on the left and right of the rear frame
part, so that the fixing eyelets and anchor symbols are facing outwards.
Pass one end of the pelvic belt through from the seat side to the outside.
Now clip the pelvic belt buckle onto the „Anchor Pin" on the anchoring
plate. Then repeat on the opposite side for the other half of the pelvic belt.