Start Basic, Start Multi - Otto Bock LISA 2005 Using Manual

7 Product Specific Instructions – Manual Wheelchairs
– Start Basic, Start Multi –
For assembly of the 481S00=SK019 fixation kit you will need the following tools:
ring wrenches sizes 10 and 13, Allen wrenches sizes 4 and 5
Attaching the anchoring points to the product
Assemble two pipe clips around the
front frame on either side of the unit.
Then attach the anchor plates us-
ing the screws provided so the fix-
ing eyelets and anchor symbols are
facing outwards.
Assembly tip: Important – Only attach the anchor plates to the frame at the indicated points, using the pipe
clips/half-shells and screws provided. Do not fully tighten the screws until the pipe clips/half-shells and anchor-
ing plates have been positioned correctly.
Unfortunately, the fixation kits cannot be used with all equipment and accessories combinations. For
existing restrictions in the combination of equipment and accessories please refer to the 647F231
Info Sheet.
Guidance for fitting the Pelvic Belt
Start wheelchair showing the cor-
rect positioning of the tie-down
straps.
This wheelchair might be equipped with back angle adjustment. Before starting adjust the backrest
to almost upright position and check if the locking mechanism on either side has engaged. Observe
the specifications in the Instructions for Use Manual of the wheelchair.
62
Mount anchor plates to the inner sides on the left and right of the rear
frame part, so that the fixing eyelets and anchor symbols are facing out-
wards.
Pass one end of the pelvic belt through from the seat side to the outside.
Now clip the pelvic belt buckle onto the "Anchor Pin" on the anchoring
plate. Then repeat on the opposite side for the other half of the pelvic belt.