Lisa - Otto Bock LISA 2005 Using Manual

5 Product Specific Instructions - Rehab Buggy
– Lisa –
For assembly of the fixation kit HR32079700 you will need the following tools: a ring wrench size 10, an Allen
wrench size 4, pointed pliers
Attaching the anchoring points to the product
Screw the included "Anchor Pins"
into the left and right side plate an-
choring plates.
Assembly tip: Important - Only attach the anchor plates to the frame at the indicated points, using the
pipe clips and screws provided. Use pointed pliers to keep the pipe clips closed whilst assembling the anchor-
ing plate and tightening the screws. Do not fully tighten the screws until the pipe clips and anchoring plates
have been positioned correctly. To check this fold the buggy and check that the anchoring plates do not make
contact with the frame.
Guidance for fitting the Pelvic Belt
Lisa Buggy showing the correct
positioning of the tie-down straps.
This rehab buggy is equipped with back angle adjustment. Before starting check the backrest is in
almost upright position and secure it by tightening the star grips on the left and right sides of the
push handles. Observe the specifications in the Instructions for Use Manual of the Rehab Buggy.
Assemble two D20 pipe clips
around the front frame on either side
of the unit. Then attach the anchor
plates using the screws provided so
the nuts and hook symbol are facing
outwards.
Pass one end of the pelvic belt through the rear corner of the seat/ back-
rest upholstery. Now clip the pelvic belt buckle onto the "Anchor Pin"
previously screwed to the side frame anchoring plates, then repeat on the
opposite side for the other half of the pelvic belt.
Now assemble two D20 pipe clips
around the rear frame on either side
of the unit. Then attach the anchor
plates using the screws provided
so the nuts are on the inside and
the hook symbol is facing outwards.
49