Waterproofing The Camera Cable Connectors; Figure 6: Camera Cables; Figure 7: System Cable Hose And Wiring; Figure 8: Rj45 Connector And Plug - FLIR CM-6206-H1-I User And Installation Manual

Waterproofing the Camera Cable Connectors

Follow the instructions below to waterproof the connectors for the different types of cables included in
the system cable. The cables are shown below.
System Cable
To waterproof the system cable
1. Connect all the required devices to the system cable. See Figure 6: Camera Cables.
2. Coat the joints with silicone gel. There should be no gap between the connectors and the cables.
For alarm I/O connector and power connector, make sure the side with wires attached is also
sealed with silicone gel.
3. Seal the end of the rubber coating of the system cable as indicated in the figure below. Use
enough silicone gel to fill in the hose and wrap around each wire in order to properly waterproof
the cable.
To waterproof the RJ45 cable
1. Plug the Ethernet cable to the connector of the RJ45 cable.
2. Coat the joint with silicone gel. Make sure there is no gap between the Ethernet cable and the
connector in order to properly waterproof the cable.
September 29, 2016
Standard RJ45 Cable

Figure 6: Camera Cables

Figure 7: System Cable Hose and Wiring

Figure 8: RJ45 Connector and Plug

CM-6206-H1-I User and Installation Guide
Introduction to the CM-6206 IP Hemispheric Camera
Optional IP66 RJ45 Cable
13