Upgrading from the Camera’s Web Interface ..............8 How to perform the firmware upgrade ..................8 United VMS Compatibility ....................... 9 Known Issues ......................... 10 Appendix ............................12 A.1. Discovering and Configuring the Camera with DNA ............ 12 April 2, 2019 CM-6308-P1-I FW v.20190226 Release Notes...
20190226 FPGA 29171533 1.2 Firmware Version Location To download the Firmware: 1) Navigate to the FLIR Visible camera page: https://www.flir.com/browse/security/visible-security- cameras/ 2) Click on the camera of choice 3) Click "Go to support page" under the Product name Example of "Go to support page" link 4) Click on the "Resources"...
Manual follow instructions here Note: 1. To discover the CM-6308-P1-I camera in Latitude/Horizon/Meridian, select the FLIR option for the Unit Type in the Admin Center discovery. 2. The camera’s web UI is supported on Microsoft Internet Explorer 10 and above (32-bit version);...
270 Mode allows the user to disable one of the lenses of the camera in 360 mode. This may be useful in installations at the corner of buildings or similar scenes. Figure 2 – 270 Mode CM-6308-P1-I FW v.20190226 Release Notes April 2, 2019...
Key Features 3.3 Fifth Imager The Fifth Imager lens (FLIR-CM-IMG5-63P) is an add-on accessory for the CM-6308-P1-I. It allows for a fifth lens to be easily attached to the center of the camera to allow for additional coverage. Note: The camera has to be re-discovered on UVMS after attaching the accessory.
Page 10
Figure 5 – Power Type Control CM-6308-P1-I FW v.20190226 Release Notes April 2, 2019...
1. If a CM-IMG5-63P is going to be used, set the camera in 360 mode (by adjusting it physically) and attach the accessory. 2. Upgrade the camera firmware via the web UI or DNA using file CM-6308-P1-I_20190226.bin. 3. Upgrade the FPGA from the web UI using the file flirpano_a7_29171533_cs.bit. April 2, 2019 CM-6308-P1-I FW v.20190226 Release Notes...
3. Select the file. The file name is displayed (for example, flirpano_a7_29171533_cs.bit). 4. Click Upgrade. The upgrade process takes about three minutes. After the firmware has upgraded successfully, the camera reboots. The Rebooting Complete dialog box opens. viii CM-6308-P1-I FW v.20190226 Release Notes April 2, 2019...
The firmware was approved for United VMS 7.0.0.5784 and United VMS 8.0.4.6119 or higher. It is necessary to install an Update Patch for the unit to operate with United VMS 7.0 and United VMS 8.0. For additional details, please see the UVMS support documentation. April 2, 2019 CM-6308-P1-I FW v.20190226 Release Notes...
The camera is set on CBR by default. Quality parameter on UVMS is only The user has to use the web UI to effective on CVBR. change the rate control to CVBR. CM-6308-P1-I FW v.20190226 Release Notes April 2, 2019...
To download the DNA and for detailed guidelines about DNA and its usage, refer to the DNA User Manual, found on the camera product page of the website: 1) Navigate to the FLIR Visible camera page: https://www.flir.com/browse/security/visible-security- cameras/ 2) Click on the camera of choice 3) Click "Go to support page"...