Cable Connectors; Input And Output Connectors; Figure 5: Cm-6206 Camera Input/Output Connections - FLIR CM-6206-H1-I User And Installation Manual

Introduction to the CM-6206 IP Hemispheric Camera

3.3 Cable Connectors

The camera is shipped with an Ethernet cable for network and Power over Ethernet (PoE) connection
and a system cable for ground, power, I/O, and audio connections. The figure below shows the various
connectors included with the camera. The connectors, pin numbers and signal definitions are listed
below.
No Cable
1 Audio I/O
Power (12VDC)
2
(2-pin Terminal Block)
Alarm I/O
3
(4-pin Terminal Block)
4 GND
5 Ethernet Cable
- microSD Card Slot
- Reset Button

Input and Output Connectors

The alarm input and output connectors are shown below
12

Figure 5: CM-6206 Camera Input/Output Connections

Pin
Pink
Green
Black
Red
1
2
3
4
-
-
-
-
Pin No. Designation
1 Alarm In (-)
2 Alarm In (+)
3 Alarm Out (-)
4 Alarm Out (+)
CM-6206-H1-I User and Installation Guide
Definition
Audio In
Two-way audio transmission
Audio Out
DC 12V −
Power connection
DC 12V +
Alarm In −
Alarm In +
Alarm connection
Alarm Out −
Alarm Out +
GND Ground connection
RJ45 connector with LEDs for network and PoE
connections.
It is not recommended to record with the microSD card
for 24/7 continuously.
Press the button with a pointed tool for at least 20
seconds to restore the system to factory defaults.
.
Remarks
September 29, 2016