Figure 51: Send Http Notification; Figure 52: Record Video Clip; Figure 53: Upload Image By E-Mail - FLIR CM-6206-H1-I User And Installation Manual


Send HTTP notification – Select this checkbox to send a notification by HTTP. Select the
destination HTTP address from the drop-down menu and specify the parameters for event
notifications by the IO event triggered. When an alarm is triggered, the notification will be sent to
one of two specified HTTP servers. See figure below.

Record video clip – Select this box in order to save the alarm-triggered recording to your
microSDXC card or to the NAS. Enter the number of seconds for the pre-trigger buffer. Select
the first radial button if you wish to upload for a specified length of time and enter the number of
seconds. Alternatively, select the second radial button to upload while the trigger is active.
Note:
In order to use this function, make sure that local recording with a microSDXC card is
activated and that the NAS is properly configured. See

Send message by E-Mail – Select the checkbox send an alarm message by e-mail when an
alarm is triggered. The e-mail address is entered in the

Upload image by E-Mail – Select this checkbox to assign an e-mail address for sending the
image captured by a triggered alarm. The e-mail address is entered in the
Note:
Images can be sent by e-mail only when MJPEG is selected as the video stream from the
Video Format

From the E-Mail address drop-down list, select one of the two e-mail addresses.

From the Pre-trigger buffer and Post-trigger buffer drop-down lists, select the number of
frames for the buffer from 1-20 frames.
September 29, 2016

Figure 51: Send HTTP Notification

Figure 52: Record Video Clip

screen.

Figure 53: Upload Image by E-Mail

CM-6206-H1-I User and Installation Guide
Configuration and Operation
Recording for further details.
Mail screen.
Mail screen.
61