Example For Configuring The Interconnection Of Ftp Servers And Devices In And Out Of The Hgmp Cluster; (In Nat Mode) - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management
3.6.2 Example for Configuring the Interconnection of FTP Servers
and Devices in and out of the HGMP Cluster (in NAT Mode)
Networking Requirements
As shown in
the administrator switch of the cluster and other switches are member switches. The member ID
of Member-1 is 1, the member ID of Member-2 is 2 and the member ID of Member-3 is 3.
To upload files to Member-1, Member-2, and Member-3 or download files from them, you can
set up an FTP connection between the devices out of the cluster and member switches in NAT
or non-NAT mode.
Figure 3-4 Networking diagram of configuring the interconnection of FTP servers and devices
in and out of the HGMP cluster (in NAT Mode)
SFTP Server
Device
Issue 01 (2011-07-15)
#
return
Figure 3-4, all the Layer 2 switches belong to the same cluster. Administrator-1 is
NOTE
In this configuration example where the NAT mode is adopted, Member-3 accesses the FTP server
(2.0.0.1/8) out of the cluster and devices out of the cluster access the FTP server (Member-2) in the cluster.
FTP Server
2.0.0.1/8
2.0.0.2/8
Ethernet0/0/1
1.0.0.2/8
Ethernet0/0/1
Ethernet0/0/1
Member-1
Ethernet0/0/2
Ethernet0/0/1
Member-3
MAC Address
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
IP/MPLS
core
Ethernet0/0/3
Ethernet0/0/2
Administrator-1
10.0.0.1/8
......
Member-2
10.0.0.4/8
Cluster
3 HGMP Configuration
NM station
3.0.0.1/8
Log station
4.0.0.1/8
Ethernet0/0/1
Device MAC Address
119