Huawei Quidway S2700 Series Configuration Manual page 53

Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
l
Procedure
Step 1 Configure available routes between the switch and the NM stations. Details for the configuration
procedure are not provided here.
Step 2 Enable the SNMP agent.
<Quidway> system-view
[Quidway] snmp-agent
Step 3 Configure the switch to run SNMPv3.
[Quidway] snmp-agent sys-info version v3
# Check the configured SNMP version.
[Quidway] display snmp-agent sys-info version
SNMP version running in the system:
Step 4 Configure the NM stations' access rights.
# Configure an ACL to allow NMS2 to manage and disallow NMS1 from managing the
switch.
[Quidway] acl 2001
[Quidway-acl-basic-2001] rule 5 permit source 1.1.1.2 0.0.0.0
[Quidway-acl-basic-2001] rule 6 deny source 1.1.1.1 0.0.0.0
[Quidway-acl-basic-2001] quit
# Configure a MIB view.
[Quidway] snmp-agent mib-view included testview iso
# Configure an SNMPv3 user group and add a user to the group, and configure authentication
for the NMS administrator and encryption for the data transmitted between the switch and NMS2.
[Quidway] snmp-agent usm-user v3 testuser testgroup authentication-mode md5
87654321 privacy-mode des56 87654321
[Quidway] snmp-agent group v3 testgroup privacy write-view testview notify-view
testview acl 2001
Step 5 Configure the trap function.
[Quidway] snmp-agent target-host trap address udp-domain 1.1.1.2 params
securityname testuser
[Quidway] snmp-agent trap source loopback0
Issue 01 (2011-07-15)
Configure the equipment administrator's contact information on the switch.
Configure NMS2.
SNMP version
User group name
User name and password
Authentication and encryption algorithms
ACL number
IP address of the NM station
Equipment administrator's contact information
SNMPv3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SNMP Configuration
43