Huawei Quidway S2700 Series Configuration Manual page 264

Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management
This section describes how to configure a traceroute test to check the connectivity to each hop
on the network.
6.11 Configuring the SNMP Query Test
This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.
6.12 Configuring the TCP Test
This section describes how to configure a Transmission Control Protocol (TCP) test to check
the responding speed of a TCP port.
6.13 Configuring the UDP Test
This section describes how to configure a User Datagram Protocol (UDP) test to check the
responding speed of a UDP port.
6.14 Configuring the Jitter Test
This section describes how to configure a jitter test to check jitter on the network. You can
perform a jitter test only when both the client and the server are Huawei devices.
6.15 Configuring Universal NQA Test Parameters
This section describes how to set and use universal parameters for NQA test instances.
6.16 Configuring Round-Trip Delay Thresholds
This section describes how to set a round-trip delay transmission threshold in an NQA test
instance.
6.17 Configuring the Trap Function
This section describes how to configure the trap function in an NQA test instance. After the trap
function is configured, a trap message is sent to the NMS in case of transmission success or
transmission failure.
6.18 Maintaining NQA
This section describes how to maintain an NQA test instance. You can restart the test instance,
clear the statistics on the test result,to maintain a test instance.
6.19 Configuration Examples
This section provides several configuration examples of NQA.
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
254