Huawei Quidway S2700 Series Configuration Manual page 101

Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management
Issue 01 (2011-07-15)
Creating a cluster manually
These steps need to be configured only on the administrator switch or on the switch which
will be the administrator in a created HGMP cluster.
In this mode, you need to manually add member switches to the cluster.
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
ip-pool administrator-ip-address { mask-length | mask }
The range of private IP addresses used in a cluster is set.
This command can be run only before the cluster is set up. If the cluster is set up, you
are not allowed to change the range of private IP addresses used in the cluster.
NOTE
The private IP addresses used by a cluster cannot be the same as any IP address on the device.
4. Run:
build cluster-name
Names of the administrator switch and the cluster are configured and the cluster is
created.
This command can only be run on the administrator switch and the switch that does
not join any cluster.
Creating a cluster automatically
These steps need to be configured only on the administrator switch or on the switch which
will be the administrator in a created HGMP cluster.
In this mode, the administrator switch prompts you whether to add all the existing candidate
switches to the cluster.
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
ip-pool administrator-ip-address { mask-length | mask }
The range of private IP addresses used in a cluster is set.
This command can be run only before the cluster is set up. If the cluster is set up, you
are not allowed to change the range of private IP addresses used in the cluster.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
91