Using The Quick Start Guide - GE SVI II AP Quick Start Manual

Using the Quick Start Guide

The SVI II AP Quick Start Guide is intended to help an experienced field engineer install, setup, and
calibrate an SVI II AP in an efficient manner. This document provides basic installation and setup
instructions and is not intended to replace the in-depth information contained in the SVI II AP In-
struction Manual. If you experience problems that are not documented in this guide refer to the
SVI II AP Instruction Manual, call your local representative, or go to www.ge-energy.com/valves.
Sales offices are listed on the last page of this document
The steps necessary to complete the SVI II AP installation and software setup are outlined in
Table 1.
Step No.
1
2
3
4
5
6
7
8
© 2015 General Electric Company. All rights reserved
Table 1: SVI II AP Installation Steps
Procedure
Attach mounting bracket to the actu-
ator.
Install the SVI II AP magnetic assem-
bly (rotary valves only).
Assemble the SVI II AP on the bracket
that is mounted to the valve actuator.
Install the Remote Position Sensor, if
necessary.
Connect the pneumatic tubing to the
SVI II AP.
Connect the air supply to the SVI II AP.
Connect the positioner to the HART
Control Loop segment by installing
the SVI II AP wiring.
Configure/calibrate using ValVue*.
Configure/calibrate using a HART
Hand Held Communicator.
®
®
. Masoneilan SVI II AP Digital Positioner Quick Start Guide =| 13
Reference
See page 21 for rotary valve and
reciprocating valve instructions.
See page 21 for instructions.
See page 21 for rotary valve and
reciprocating valve instructions.
See Masoneilan Valve Solutions
Remote Position Sensor Quick
Start Guide (GEA31195 or P/N
011525100-888-0000) for
instructions. Use GEA or P/N
when searching on the download
website).
See page 33 for instructions.
See page 34 for instructions.
See page 35 for instructions.
See page 46 and page 49 for
instructions.
See page 53 for instructions.