GE SVI II AP Quick Start Manual page 81

10.2 Electronics Module
Make sure that:
The 4 o-rings are seated on the base of the electronics assembly and are not
damaged.
The four retaining screws are snug
10.3 I/P
Make sure that:
The wire is not damaged when feeding it through the housing.
A single o-ring is in place on the wire-sleeve and is not damaged.
The four retaining screws are snug.
Inserting the wire sleeve through the housing does not require force.
10.4 Relay
Make sure that:
The five o-rings are seated in the base of the relay and are not damaged
The three mounting screws are snug.
10.5 Pneumatic Cover
Make sure that:
The gasket is seated in the groove.
The retaining screws are snug.
11 LISTING OF APPLICABLE STANDARDS
General Requirements
Intrinsically Safe
Flameproof
Encapsulation
Dust Protection
Equipment Protection Level
FM Approvals
General Requirements
Intrinsically Safe
Non-Incendive
Explosion proof
Suitable for Use
Measurement, Control and Laboratory USe
Housing
Housing
CSA
ES-699 Rev AA
Page 15 of 16
© 2015 General Electric Company. All rights reserved
ATEX
EN 60079-0 : 2012
EN 60079-11 : 2012
EN 60079-1 : 2007
EN 60079-18:2009
EN 60079-31: 2009
EN 60079-26:2007
Class Division Classification
Class 3600 : 2011
FM 3610: 2010
FM 3611: 2004
FM 3615 : 2006
FM 3611: 2004
FM 3810: 2005
ANSI/NEMA 250: 2003
ANSI/IEC 60529: 2004
Class – Division Classification
. Masoneilan SVI II AP Digital Positioner Quick Start Guide =| 81
IEC
IEC 60079-0: 2004 Ed. 4
IEC 60079-0: 2007-10 Ed. 5
IEC 60079-11: 2006 Ed. 5
IEC 60079-1: 2007-04 Ed. 6
IEC 60079-18: 2004 Ed. 2
IEC 61241-0: 2004 Ed.1
IEC 61241-1: 2004 Ed.1