Preparing The Spray Gun - WAGNER PEM-X1 Operating Manual

VERSION 03/2014
OPERATING MANUAL
6.4

PREPARING THE SPRAY GUN

6.4.1
SELECTION OF THE SUITABLE NOZZLE SYSTEM
The process of changing from the fan spray nozzle to the defl ector cone is described in
Chapter 8.8 "Changing from Fan spray nozzle to Round spray nozzle".
You will fi nd the article numbers of the diff erent nozzles in Chapter 12 "Accessories".
Nozzle Application overview
Fan spray nozzle Complex part geometries
P_01664
Defl ector cone
P_01665
Nozzle Application
Universal
P_01664
The spray width can be adjusted by the sliding ring.
P_02209
ORDER NUMBER DOC 2326020
Flat work pieces
(reduced picture frame)
Profi les
Undercuts
Wire goods
Grid designs
Small components
Deep and complex part
geometries
Extensive work pieces
Rear sliding ring
Wide cloud
Cloud opening angle approx. 80°
Front sliding ring, front
Narrow cloud
Cloud opening angle approx. 60°
Front sliding ring, front, turned by 90°
Extra narrow cloud
Cloud opening angle approx. 40°
Powder cloud
Widely spread fl at powder cloud
Round powder cloud:
Size of the powder cloud is
dependent on the defl ector plate
diameter
Distance to Powder output
work piece
(mm) (g/min)
120 ... 300 50 ... 300
PEM-X1
22