2
Displaying Data
Figure 19
To specify the probe attenuation
For correct measurements, you must match the oscilloscope's probe
attenuation factor settings with the attenuation factors of the probes being
used.
The probe attenuation factor setting changes the vertical scaling of the
oscilloscope so that the measurement results reflect the actual voltage
levels at the probe tip.
1 If the channel's menu is not currently displayed, press the channel key
2 In the Channel menu, press Probe.
3 Continue pressing the Probe softkey or turn the
50
Bandwidth ON Status
BW Limit Control ON
([1], [2], [3], or [4]).
the appropriate attenuation factor.
Agilent 1000B Series Oscilloscopes User's Guide
20 MHz Bandwidth
entry knob to select