Custom Labeling Of Leds - GE Multilin g60 Instruction Manual

Ur series generator protection system

Hide thumbs Also See for Multilin g60:

Table of Contents

4 HUMAN INTERFACES

GROUP 1...6: The illuminated GROUP is the active settings group.

SYNCHROCHECK NO1(2) IN-SYNCH: Voltages have satisfied the synchrocheck element.

Firmware revisions 2.9x and earlier support eight user setting groups; revisions 3.0x and higher support

six setting groups. For convenience of users using earlier firmware revisions, the relay panel shows eight

setting groups. Please note that the LEDs, despite their default labels, are fully user-programmable.

The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the

pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The

LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained

in the following section.

a) ENHANCED FACEPLATE

The following procedure requires the pre-requisites listed below.

EnerVista UR Setup software is installed and operational.

The G60 settings have been saved to a settings file.

The G60 front panel label cutout sheet (GE Multilin part number 1006-0047) has been downloaded from

www.GEindustrial.com/multilin/support/ur

Small-bladed knife.

This procedure describes how to create custom LED labels for the enhanced front panel display.

Start the EnerVista UR Setup software.

Figure 4–21: LED PANEL 2 (DEFAULT LABELS)

and printed.

G60 Generator Protection System

4.3 FACEPLATE INTERFACE

842785A1.CDR

4.3.3 CUSTOM LABELING OF LEDS