Overheat Error Messages - DEC DECstation 5000 Model 200 Maintenance Manual

Table 4-4. Hardware Physical Addresses
Physical Address Range
00000000 to 1DFFFFFF
1E000000 to 1E3FFFFF
1E400000 to 1E7FFFFF
1E800000 to 1EBFFFFF
1EC00000 to 1EFFFFFF
1F000000 to 1F3FFFFF
1F400000 to 1F7FFFFF
1F800000 to 1FBF0000
1FC00000 to 1FFFFFFF
Replace the FRU that contains the hardware indicated by the
error log. For directions, refer to the section in Chapter 5 of
this guide, or the TURBOchannel Maintenance Guide that
discusses the FRU you want to replace.

Overheat Error Messages

If the system reports an overheat error, shut down the system
software and then turn off the system power. Refer to ''Power
Supply'' in Chapter 5 to troubleshoot the power supply fans.
Indicated Hardware
Main memory
Module in option slot 0
Module in option slot 1
Module in option slot 2
Reserved
Reserved
SCSI controller on the system module
Ethernet controller on the system module
System module interface
Identifying Failed FRUs 4–9