Shutting Down the System Software
If the system is running ULTRIX software, shut down the
system before you perform customer service. To shut down the
software, type the following command at the ULTRIX prompt:
/etc/shutdown -h (now | hhmm | +n)
Specify the now parameter to shut down the software
immediately.
Specify hhmm to shut down the software at a specified
time. Replace hhmm with the hour and minute the
shutdown begins, where
Specify +n to shut down the software in a specified number
of minutes. Replace n with the number of minutes until
shutdown begins.
The monitor displays the prompt
complete.
2–24 Service Operations
hh represents the hour to begin the shutdown.
mm represents the minute to begin the shutdown.
or
when shutdown is
>>
R>