scsi prb Command
The scsi prb command displays all the devices on a SCSI bus.
To use the scsi prb command, type scsi prb szn(x), where x
represents the device specification for the SCSI controller of
the bus you want about which you want information, and press
Return. Note that the device specification is different than the
controller's unit number.
The monitor's scsi prb display looks similar to this:
6: *
5: Pid="", Vid=", Rev=""
0x0001d001<PDT=Tape,PQ=0,DTQ=50,RMB,ANSI=1,RDF=0>
0x00000000
3: Pid="RZ56" (C) DEC",
0x01010000<PDT=Disk,PQ=0,DTQ=0,ANSI=1,RDF=1>
0x1000001f<Alen=31,Sync>
In this display, the numbers in the left column are the device's
SCSI addresses. An asterisk appears after the SCSI controller's
address. Lines after other SCSI addresses show additional
information about the device. Table E-2 describes the terms
used in these displays.
Console Commands Generated by Version PDE3 ROM Chips E–11
Vid="DEC", Rev="0102"