Table of Contents
Advertisement
Operating instructions SPEEDY F4 & F2
Side panel guide
Locking pin
Figure 45: Locking pin engages in the locking hole
in the side part (shown without clothing guard and
equipped with an knee-lever brake)
Figure 46: Locking pin engaged in the mounting bar
of the clothing guard (view with clothing guard)
21.3.2 Removal and attachment of the
clothing guard
To remove the clothing guard, the locking
pin must be pulled out of the mounting bar first.
For this purpose, grasp under the seat
upholstery and in the middle, pull the cord to
the front that is linked to the locking pin and
keep it in this position.
Locking pin
engaged in the
mounting bar
Locking pin
Figure 47: Locking pin (view from the inside of the
frame) linked to the cord
Cord
Pull from the
middle to the front
Figure 48: Cord for pulling the locking pin
Observe: In case you are sitting in the
product when removing the clothing guard, you
have to relieve the backrest before pulling the
cord.
Now, first the clothing guard can be removed
from the side panel guide for the mounting bar
(then the cord can be released again) and
pulled from behind the back joint shaft.
24
Advertisement
Table of Contents
