Clothing Guard; Side Panel With Integrated Clothing Guard; Side Panel With Bolt-On Clothing Guard; Overview Of Terms - ProActiv SPEEDY F4 Operating Instructions Service Booklet

Hide thumbs Also See for SPEEDY F4:
Table of Contents

Advertisement

Operating instructions SPEEDY F4 & F2
It is mandatory to use a seat cushion on
the seating system. At cold temperatures, the
seat cushion prevents lower abdomens from
undercooling and protects against dirt and
wetness. Moreover, the cushion ensures
uniform pressure distribution for your bottom
and absorbs impacts as well as vibrations.

21 Clothing guard

21.1 Side panel with integrated
clothing guard
In the version of the product with a "side panel
with integrated clothing guard", the side panel
and the clothing guard are made in one piece
and bolted onto the backrest and product
frame. There is no possibility to remove the
clothing guard and no possibility to adjust the
clothing guard from its position to the drive
wheel.
Figure 36: Side panel with integrated clothing guard
(shown without the drive wheel)
21.2 Side panel with bolt-on clothing
guard

21.2.1 Overview of terms

If the product is fitted with a "side panel with
bolt-on clothing guard" the clothing guard is
fitted on each side with two M5 mounting bolts
(AF 3 mm) with washers and two clothing
guard brackets are screwed onto the side
panel.
Rear M5 mounting bolt with
washer
Front M5 mounting bolt with
washer
Figure 37: Side panel with bolt-on clothing guard
and M5 mounting bolts (shown without the drive
wheel)
Clothing guard mount
Figure 38: Clothing guard mount
21.2.2 Removal and attachment of the
clothing guard
The clothing guard can be removed on each
side by loosening the two M5 mounting bolts
(AF 3 mm) with the washers and removing the
two clothing-guard brackets.
21.2.3 Adjusting the clothing guard
position
To adjust the clothing guard's position to the
drive wheel, the hole pattern in the front area
of the clothing guard can be used. To do this,
loosen the front M5 mounting bolt (AF 3 mm)
with washer on both sides. Position the
clothing guard as desired and insert the M5
mounting bolt with washer in the corresponding
hole of the hole pattern and into the clothing
guard bracket. Tighten up the M5 mounting
bolt (AF 3 mm) to 4 Nm.
22

Advertisement

Table of Contents
loading

This manual is also suitable for:

Speedy f2

Table of Contents