Table of Contents
Advertisement
Operating instructions SPEEDY F4 & F2
M4 End stop screw
Figure 162: End stop screws mounted at the bottom
of the push handles offset to the back
If necessary the tension can be adjusted
by turning the quick release lever clockwise
until it reaches the end stop.
Before using each time, the M4 end stop
screws (AF 3 mm) need to have been mounted
again.
27.6 Safety instructions
After every adjustment or after
reattachment following removal, check that the
push handles are firmly attached in position.
Due to environmental effects, it is possible
that the properties and therefore secure
attachment of the push handle covers may
change detrimentally. For this reason, it is
important to check the handles are tightly fitted
and fixed in position prior to use. If this should
no longer be the case, then the push handles
may not be used until they have been fixed
28 Storage
When being stored, the product should be kept
in a dry environment and covered up where
possible.
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
not be exposed to any aggressive
environmental influences (salt in particular).
29 Transport
29.1 Securing handling of the product
When loading or transporting, the product can
be held on the frame and on the back cross
bar.
29.2 Transporting people in a car
vehicle occupants must only sit on the seats
installed in the vehicle during the journey with
the associated restraint systems. Failing to
observe this leads to increased risk of injury for
the user as well as for third-parties.
The product can be fitted with a headrest.
These headrest systems are not suitable for
use as headrests when being transported in a
motor vehicle.
The waist belt which may be fitted is not
designed as a safety belt in a motor vehicle
and may not be used for this purpose.
29.3 Securing the product in a car
(without a person)
To reduce the weight, individual
.
components, such as the caster wheel forks
with caster wheels and the drive wheels can be
removed from the product for loading and
stored separately. The product and all
associated components must be secured
during transport so that they are not damaged
(e.g. by falling over) and do not become a
hazard to persons or other products. Check
with your car dealer before transport about the
risk-free securing using the existing fitted
lashing rings or other securing devices.
Suitable brackets are mostly available in the
car and are described in the operating manual
of the vehicle.
Transporting people, be it
the wheelchair user or
other persons, in vehicles
has not been tested by
PRO ACTIV and is
therefore not approved. All
56
Advertisement
Table of Contents
