Table of Contents
Advertisement
Operating instructions SPEEDY F4 & F2
Locking pin
Figure 7: Locking pin engages in the locking hole in
the side section (view from the outer side of the
product)
Cord
Pull from the
middle to the front
Figure 8: Cord for operating the locking pin and thus
for adjusting the angle of the backrest
If you have released both locking pins by
pulling on the cord, you can adjust the backrest
as desired and re-engage it by letting go of the
cord. In doing so, before applying load again,
make sure that both locking pins have
engaged safely into the desired locking holes
(the same position on the right and left).
For safety reasons, the adjustment range of
the backrest is limited by a stop pin when
supplied. The stop pin allows a maximum
inclination of 7° to the rear from a vertical
position.
Stop pin
Figure 9: Stop pin
Depending on the adjustment of the
backrest angle, check the tight engagement of
the backrest via the locking pins.
To fold down the backrest, pull on the middle
of the cord towards the front, and at the same
time, fold the backrest downwards until it rests
on the seating area. If you want to return the
backrest back to the desired angle, proceed as
described at the beginning.
19.2 Adjustable back padding & their
adjustment options
The back system "Adjustable back padding"
comprises one belt system and one back
upholstery. The slack of the backrest can be
adapted to the individual requirements via the
belts with tensioning loops.
First remove the back upholstery that has been
covered over which has been attached using
hook-and-loop straps. The belt system located
underneath has been set in the factory that the
top and the bottom belts have a slack of
approx. 2 cm. The middle belts have been
pulled tight for a good lumbar support.
16
Advertisement
Table of Contents
