Table of Contents
Advertisement
Operating instructions SPEEDY F4 & F2
31 Cleaning and care
Regular cleaning of the product is prescribed
to prevent the components becoming clogged
up due to dirt. In particular, the product should
be carefully cleaned after every major use, e.g.
summer or winter holidays.
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
not be exposed to any aggressive
environmental influences. If this cannot be
avoided, the product should be cleaned
immediately after such use and moving parts
need to be greased. Regular cleaning prevents
corrosion and increased wear.
In case the product becomes wet when using,
dry it after use.
Clean the quick release axles of the drive
and caster wheels as well as the ball bearings
and grease these with a little lubricating oil with
high corrosion protection properties (e.g.
Neoval MTO 300) approx. every 8 weeks in
order to guarantee the reliable functioning
properties.
Clean your product with water, solvent or
neutral cleaning agents. Do not use any
abrasive cleaning agents or aggressive, acidic
cleaners, to prevent scratching or fading of the
coating or the anodised parts. Only use water
and soap to clean the seat and back padding.
The product must not be cleaned using
steam or high pressure.
32 Maintenance
32.1 General instructions
The product is not a maintenance-free device.
Therefore, please observe the following
instructions about maintenance.
If repairs are required or there are any
defects in your product, in the interests of your
own safety, you should contact your
rehabilitation specialist retailer or PRO ACTIV
before using it again and have the defect
remedied. Screws and other elements need to
be secured properly again after repairs.
For tyres with tread: As soon as there is
one or more points with less than 1 mm of
tread on the tyres, the tyres must be changed
as otherwise there is an increased risk of an
accident.
For tyres without thread: As soon as there
is one or more points where the tyre carcass or
the puncture-proofing is visible, the tyres must
be changed as otherwise there is an increased
risk of an accident.
Only manufacturer's original parts may be
used when ordering spare parts.
Repairs and conversions to the product
may only be carried out by your rehabilitation
specialist dealer or PRO ACTIV.
Tightening torques and securing details for
fastening elements as shown in the table in
chapter 37 must be observed.
32.2 Service schedules
There is some maintenance work or checks
which should be carried out by the user
themselves at regular intervals (approximately
every 4 weeks depending on the frequency of
use):
Check the tyres for damage, foreign bodies
and any cracks that form.
Check the tyre pressure and correct if
needed (the tyre pressure should always
be as printed on the tyre covers).
Check the brakes (function, wear on pivot
bolts).
Clean and oil the pivot points of the brakes
and check the ease of movement or
actuation force of the brake lever.
Check the function of the anti-tipping
device.
Check the stable stand of the seat and
back padding.
Check the tight fit of the fixing screws on
the seat and back system.
58
Advertisement
Table of Contents
