Table of Contents
Advertisement
Operating instructions SPEEDY F4 & F2
Locking pin
lever in
horizontal
position, not
engaged
Figure 110: Locking pin lever in horizontal position,
not engaged and thus not resting against the footbar
joint
As soon as an engaged position is reached
during the return movement, the locking pins
engage and the levers rest against the footbar
joint.
Figure 111: Locking pin lever in horizontal position,
engaged and thus resting against the footbar joint
If you want to move the footrest back into the
standard position, perform the as previously
described and during this process, move the
footrest to the front.
After folding up to the back each time, take
care that the footrest has engaged correctly
again. This is visible when the locking pin lever
rests against the footbar joints (Fig. 111).
Locking
pin lever in
horizontal
position,
engaged
For the longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length, the M6 fixing screws (AF 4 mm) must
be undone on both sides on the outside of the
frame tube. Fix the footrest support tubes to
the inlets using the M6 fixing screws (AF
4 mm) that have 3 holes that serve the setting
of the lower leg length. Only an extension of
the lower leg length is possible as the footrest
support tube is always fixed in the top hole of
the inlet.
M6 fixing screw
with washer
Figure 112: M6 fixing screw with washer to adjust
the lower leg length
Figure 113: Inlet with 3 holes
Once the M6 fixing screws (AF 4 mm) have
been loosened on both sides, move the
footrest support tubes so that the holes on both
sides of the footrest support tubes are
positioned accurately over the holes
underneath. Take care that the same holes are
used on both sides.
Support tube
42
Advertisement
Table of Contents
