Table of Contents
Advertisement
Figure 49: Clothing guard pulled from the side panel
guide to the front (shown without drive wheel)
To mount the clothing guard, this is first
connected to the rear of the back joint shaft
with the mounting bar, then the mounting bar is
inserted at the front in the side panel guide and
pressed downwards until the locking pin
engages in the mounting bar.
Figure 50: Mounting bar pinned on the rear pivot
shaft (shown without drive wheel)
21.3.3 Adjusting the clothing guard
position
After changing to different tyres, the clothing
guard position may need to be adjusted to suit
the wheel arch. The distance between the
tyres and the clothing guard should be
between 5 and 8 mm to avoid pinching your
fingers, scraping the tyres on the clothing
guard, and obstruction when grasping the
handrim.
25
Operating instructions SPEEDY F4 & F2
To adjust the clothing guard position, loosen
the two M5 fixing screws (AF 3 mm) from the
clothing guard mount on each of the clothing
protection guards.
Figure 51: Clothing guard mount
M5 fixing screws
Slots of the
mounting bar
Figure 52: M5 fixing screws and slots on the
mounting bar
Now the mounting bar can be brought into
position using the slots of the clothing guard
and the mounting bar.
Finally the clothing guard mounts are
positioned accordingly and the M5 fixing
screws (AF 3 mm) are screwed back into the
clothing guard mounts with 4 Nm.
Slots of the clothing guard
Figure 53: Slots of the clothing guard
Clothing guard
mount
Advertisement
Table of Contents
