Table of Contents
Advertisement
Operating instructions SPEEDY F4 & F2
21.3.4 Clothing guard size
The clothing guard is available in three
different sizes. The dimensions of the wheel
arches differentiate with the different sizes:
Aluminium: 30 mm (Size 1), 36 mm
(Size 2), 46 mm (Size 3)
Carbon: 30 mm (Size 1), 36 mm (Size 2),
42 mm (Size 3)
Dimensions of the wheel arches
Figure 54: Dimensions of the wheel arches
The size of the clothing guard can be read-off
the notches on the bottom edge of the clothing
guard. One notch means size 1, two notches
mean size 2 and three notches mean size 3.
Size marking for size 2
Figure 55: Size marking on the clothing guard
After changing to a wider tyre size or after
changing the wheel camber, it may be
necessary to change to another clothing guard
size. Where required, such a change may be
arranged by your rehabilitation specialist
dealer.
22 Drive wheels
22.1 Removing and attaching the drive
wheels
Locking knob of the
quick-release axle
Figure 56: Locking knob of the quick-release axle in
the middle of the wheel axle
To remove the drive wheels grip through the
spokes around the wheel hub with your fingers.
By pressing the locking knob in the middle of
the wheel axle with your thumb, the wheels
can then be removed.
When attaching the drive wheels, the locking
knobs must be pressed and the drive wheels
with quick-release axle must be inserted in the
drive wheel bearings. When doing this, special
attention should be paid to ensure that the
locking knob springs out again after attaching
the wheel, as otherwise the wheels are not
properly secured. You will know this if you can
see the index groove.
Figure 57: Quick release axle with index groove
Before using the product, check if the
wheels are secured and that the quick release
axles are locked.
Index groove
26
Advertisement
Table of Contents
