CipherLab RS30 Reference Manual page 125

HOW TO OUTPUT
After the output destination is set, configure how to output decoded data, i.e. the "format"
to present decoded data.
Setting
Auto Enter
Auto Enter character
Display Code Type
Show Code Length
Prefix
Suffix
Field Delimiter
ENABLE READER
Features a switch to enable or disable reader scanning ability. When enabled, a light beam
will be sent out from the scanning window each time the trigger (scan key) is pressed.
NOTIFICATION SETTINGS
Description
Adds an ENTER character before or after each string of
decoded data. The ENTER character can be defined in the
"Auto Enter character" field below. This function saves the
trouble of pressing a confirmation key to accept each string of
decoded data. Options are:
Disable
Decoded data + Enter char
Enter char + Decoded data
Adds a key code before or after the decoded data. If [Auto
Enter] is enabled, select the ENTER character to send.
Options are:
None
Carriage Return
Tab
Space
Comma
Semicolon
Prefixes the output data with code type information.
Suffixes the output data with code length information.
Affixes 0 to 10 characters to the left of the output data. Tap
the label to open a character table for entering the prefix.
Prefixes containing invisible characters are supported.
Affixes 0 to 10 characters to the right of the output data. Tap
the label to open a character table for entering the suffix.
Suffixes containing invisible characters are supported.
Sets the delimiter to separate the output barcode data to the
following pieces: code type, decoded barcode data, and code
length (if applicable). Options are:
None
Comma
Semicolon
Full stop
Chapter 6 Using Reader Configuration Utility
Default
Decoded data
+ Enter char
Carriage
Return
Deselected
(Disabled)
Deselected
(Disabled)
--
--
None
111