About Pc Card - Teac GX-1 Instruction Manual

About PC Card

Inserting a PC Card
To insert a PC card:
1.
Turn on the power to the GX-1 main unit.
The buzzer will sound three pairs of beeps.
2.
Open the door to the PC card slots.
3.
Insert the PC card with its label side faced up in the direc-
tion of the arrow written on the label. Push the card firmly
into the slot.
4.
Close the door to the PC card slots.
(The status toolbar still shows "NO MEDIA".)
Removing the PC Card
Note
Do not insert or eject the PC card unless the unit is in
the recording STOP mode or the power is turned off.
Otherwise, the data recorded on that PC card might
become unreadable.
To remove a PC card:
1.
Open the door to the PC card slots.
2.
Push the button on the left of the slot and remove the PC
card.
3.
Close the door to the PC card slots.
Use Specified PC Card
Use PCMCIA TYPE II flash ATA cards manufactured by
HITACHI. Writing and reading cannot be guaranteed if any
other PC card is used.
When you use an unused PC card, format the card by choos-
ing File and then Format to enter a volume label.
Data in PC Card
To record data to a PC card, first create a folder in the PC card,
and then record data into that folder. The data recorded on a
PC card can be read by a PC's PC card slot as TAFFmat files
and can be processed using commercially available analytical
software.
When inserting PC card into PC's slot
Do not delete, move, or rename files or folders in a PC card. If
you delete, move, or rename files or folders in a PC card, the
link between the data file and the header file will be lost, and as
a result, the data become unreadable by PC or GX-1.
Installation
2-11