Teac GX-1 Instruction Manual page 43

Basic Operations
6.
Click the Start button (
7.
Click the Stop button (
Reproducing pauses at the current point of the data. Clicking the Stop button
twice stops reproducing and locates the the beginning of the data.
Click the Start button to restart reproducing.
8.
To reproduce another file in the same device (or folder), double-click on the
desired file on the PLAY tab and click the Start button.
Setting Analog output Amp
To set the analog output amplifiers, choose Params from the Setup menu in the
same way as for signal conditioners. To change the settings after you open a file to
reproduce, proceed as follows:
1.
Click button on the toolbar.
The output monitor screen is displayed.
2.
Click button on the toolbar.
3.
In the dialog that appears, select desired channels, output range, offset, and filter
cutoff frequency.
4.
Click OK.
Click the channel
you want to set.
Turn on to display
the settings on this
dialog on the Output
Monitor screen.
3-16
) to start reproducing.
) to make reproducing pause.
Select the slot of the channels you want to repro-
duce. The slot numbers in the expansion unit are
added eight. If you remove the expansion unit
when you reproduce the data recorded with the
expansion unit installed, you cannot select the slots
in the expansion unit.
When reproducing data recorded at a low sam-
pling frequency, it may take some time until the
waveform appears. Please note that, if the
recording time is short, the reproduction may
be finished before the waveform appears.
Reproducing frequency is same as the sampling
frequency.
Reproduction of data recorded in AIT
Data cannot be reproduced continuously when
the recording rate—sampling frequency multi-
plied by number of recording channels—is 800
k data/s or higher. Reproduction pauses when
the buffer becomes empty. When reproduction
pauses, click the Start button to resume repro-
duction.
Waveform time axis in AIT reproducing
When the recording rate is 800 k data/s or high-
er, the time axis is fixed to one second.
Setting changes explained here are not reflected
in the settings done by Setup/Params.
Set output range. The output
ranges and the units cannot be
matched with the input settings
depending on the type of amplifiers.
Set offset.
Select cutoff frequency of output fil-
ter.