Table of Contents
Advertisement
Specifications
Number of channels :
2
Input format :
CMOS level, 16 bits each channel
Output format :
Open drain, 16 bits each channel
Input/Output switching:
Slot by slot
Sampling frequency :
1 Hz to 200 kHz
Trigger:
AND/OR selectable for specified bits
Input/Output connector :
JAE TX20A-36R-D2LT1-A1LH (amp side)
A connector and a cable attached (one end stripped)
Settings
The following dialog box appears when you choose Setup and Params, and then
double-click the channel that you want to set.
Channel :
Select ENABLE to enable this channel, or select DISABLE to
disable this channel.
Sample Frequency : You can select 10 times the Base Sample Freq when you
turn on Multi Sampling check box.
Input/Output :
Select whether to use this amp as an input (recording) amp or out-
put (reproducing) amp.
Channel Name : You can name the channel. Use up to 16 alphanumeric characters.
Output Slot :
When you use this amp as an output (reproducing) amp, select the
slot of the channel you want to reproduce.
Display Bit :
Select the bits you want to display in the graphs.
All DIO Amp Same Condition : When this option is selected, the same parameters
are set for all signal conditioners of the same type.
Amplifiers
Enable both channels of a slot.
When Output is selected, digital monitor out-
put of the recording signal of another channel is
possible.
4-37
Advertisement
Table of Contents
