About Recording - Teac CD-RW890MKII Owner's Manual

Programmed Playback (2)
To delete a track from the program
1
In the stop mode, press the PROGRAM CHECK button
repeatedly until the program number to be deleted
appears on the display.
2
Press the CLEAR button.
The track is removed from the program, and the program numbers
of the following tracks are moved up .
To clear the program
In the stop mode, hold down the CLEAR button for more than 2
seconds .
If one of the following buttons is pressed, the programmed contents
will also be cleared .
OPEN/CLOSE (L), POWER
16

About Recording

CD-R and CD-RW
A CD-R disc can be recorded only once . Recorded tracks cannot be
erased . However, if some recording time is still available, additional
recording is possible . If you finish recording and finalize the CD-R
disc, it can be played with a normal CD player . (Some CD players
may not be compatible . )
On a CD-RW disc, even if no recording time is available, you can
erase tracks already recorded and record tracks repeatedly . You can
erase all tracks at once or the last track only . However, you cannot
erase only tracks in the middle of the disc .
CD-RW discs can only be played with compatible CD players .
Serial Copy Management System
This unit is in compliance with the Serial Copy Management
System standard . This standard has been established to restrict
digital-to-digital copying to only the first generation . The basic
rules governing this system are as follows:
Rule 1
A digital recording is possible from a digital source such as a CD,
DAT or MD onto a recordable CD-R, CD-RW, MD or DAT through
a digital input connection . However, further digital to- digital
recording is prohibited for the second and later generations .
Rule 2
When an analog source such as an analog disc or FM broadcast
is digitally recorded by using a CD-R, CD-RW, MD or DAT, this
recorded source can be digitally recorded on another CD-R,
CD-RW, MD or DAT . However, further digital copying is prohibited .