Opening Lists With The Message Key - Siemens GIGASET A580 User Manual

Using lists

Opening lists with the message key

You can use the message key f to open the following list selection:
u
Calls list
u
SMS list
u
Network mailbox
A separate list is displayed for each network mailbox.
Precondition: Its number is saved in the base station, it is switched on
£
( Page
assigned to the handset as a receive number.
An advisory tone sounds as soon as a new message arrives in a list. The f
key flashes (it goes off when the key is pressed). The message
sages appears in the display in idle status.
List selection
The lists displayed after pressing the message key f depend on whether
there are any new messages.
f key does not flash (no new messages): All lists are displayed. Select a list
with q. To open, press
f key flashes (new messages received): All the lists that contain new mes-
sages are displayed as well as the network mailbox lists, whose connection is
assigned to the handset as a receive number
Incoming SMS message list
All received SMS messages are saved in the incoming message list
Network mailbox lists
If you select a network mailbox list and press
the network mailbox. For information on the network mailbox
Calls list
Precondition: Calling Line Identification (CLIP
The calls list contains the last 20 numbers, depending on the type of list set
u
all calls
– answered calls
– unanswered calls
u
missed calls
– unanswered calls
Multiple calls from the same number will be stored once in the list of missed
calls (the latest call). The number of calls from this number is shown in brackets
after the entry.
Multiple calls from the same number are stored several times in the list of
answered calls.
60
£
Page 69
£
Page 75
132) and the corresponding VoIP/fixed line network number is
.
§OK§
You have new mes-
(Netz-AB Phone, Netz-AB
, you are connected directly to
§OK§
£
£
Page 43)
IP1,...).
£
Page 69.
Page 75.