Opening Lists With The Message Key; Dialling From The Directory/List - Siemens Gigaset S450 IP Manual

Using the directory and lists
Opening lists with the
message key
You can open the following lists with the
message key f:
u
SMS list
If several mailboxes are set up, several
lists are displayed where applicable.
u
Incoming e-mail list
The list is only displayed if there are
new messages in the mailbox on the
incoming e-mail server.
u
Messenger message list
The list is only displayed on the online
handset.
u
Network mailbox
If your network provider supports this
function and the network mailbox is set
up for fast access via key 1 (page 15).
u
Calls list
You can configure your calls list to
include all calls or just missed calls.
¢
v Ð
Settings
¢
Calls List Type
Note:
Your calls list will only save calls made to the
receiving numbers assigned to your handset
(page 30).
An advisory tone sounds as soon as a new
message arrives in a list. The f key
flashes (it goes off when the key is
pressed). In idle status, the display shows
an icon for the new message.
Icon New message...
Ã
... in network mailbox
Á
... in calls list
À
... in SMS, messenger or e-mail
list
The number of new entries is shown
beneath the corresponding icon.
22
¢
Base
If you press the f key, the lists contain-
ing messages will be displayed (exception:
network mailbox). Lists with new mes-
sages are displayed in bold.
Opening a list
¢
f
If necessary, select the list
q
Select entry.
You will find additional information about
the lists in the detailed user guide for your
Gigaset S450 IP on the Internet at
www.siemens.com/gigaset.

Dialling from the directory/list

¤
Open the directory/list.
¤
Select entry via q.
¤
Press and hold/briefly press the talk
key c (page 17).
Note:
You can only dial IP addresses via VoIP.