Setting Sms Centres - Siemens GIGASET A580 User Manual

Changing the character set
You are reading an SMS.
The SMS contains symbols and has probably been created with a foreign
character set.
§Menu§
Character Set
Text is shown in the selected character set.
After closing the SMS, the settings are reset.
Adding the number of the message sender to the directory
You are reading an SMS in the incoming message list.
¤
Pressing the display key
¤
Complete the entry,

Setting SMS centres

Entering/changing SMS centre number
¤
You should find out about the services and special functions offered by your
service provider before you make a new application and before you delete
preconfigured phone numbers.
¢
§Menu§
Service Centres
q
SMS
~
a
To activate an SMS centre as the active send service centre
Normally an SMS is sent via
¢
§Menu§
Service Centres
q
Active Send Srvc. Cent.
If a different SMS centre was active previously, then this will be deactivated. For
SMS centres 2, 3 and 4, the settings only apply to the next SMS. After this,
centre # 1
Press the display key.
§Menu§
£
Page
¢
SMS Settings
Select and press
§OK§
Select an SMS centre (e.g.
Select and press
§OK§
Enter and change the SMS centre number and press
Press and hold (idle status).
SMS centre #
¢
SMS Settings
Select and press
§OK§
Select an SMS centre (e.g.
sent, and press
§OK§
Select and press
§OK§
is reset.
.
64.
SMS centre #3) and press
.
1.
.
SMS centre #
.
, to activate the SMS centre (‰ = on).
SMS (text messages)
.
§OK§
.
§OK§
3) via which the SMS is to be
SMS
71