Siemens simatic et200sp Manual page 105

Error code in STATUS parame-
ter
(hexadecimal)
Byte 0 Byte 1 Byte 2 Byte 3
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
DF 80 E1
Analog input module AI Energy Meter 480VAC ST (6ES7134-6PA20-0BD0)
Manual, 12/2015, A5E36061895-AA
A.2 Structure of the parameter data record 128 for the entire module
Meaning
21 Parameter for user data variant not possi-
ble.
22 Parameter for user data variant is invalid.
23 Parameter for frequency is invalid.
24 Parameter for tolerance line voltage is
invalid.
25 Parameter for current transformer second-
ary is invalid.
29 Parameter for tolerance factor overcurrent
invalid.
2A Parameter for tolerance time overcurrent
invalid.
2B Parameter for low limit measuring current
invalid
2C Parameter for current transformer primary
current is invalid.
2D Parameter for voltage converter primary
voltage invalid.
2E Parameter for voltage converter secondary
voltage invalid.
2F Parameter for full-scale value for energy
counters invalid.
30 Invalid data record number.
3E Only for connection type 3P4W1.
Parameters for the different phases are not
identical.
3F Full-scale value for energy counter too
small or transmission ratio of current and
voltage too high.
Parameter data records
Solution
Check Byte 9. Select a different user data
variant or change the configuration.
Check Byte 9. Select a valid code for the
user data variant.
Check Byte 6. Enter valid values.
Check Byte 7. Enter valid values.
Check Bit 4...5 in Byte 22, 42...62. Enter
valid values.
Check Byte 15, 35...55. Enter valid values.
Check Byte 16...17, 36...37, 56...57. Enter
valid values.
Check Byte 23, 43...63. Enter valid values.
Check Byte 18...21, 38...41, 48...61. Enter
valid values.
Check Byte 26...29, 46...49, 66...69. Enter
valid values.
Check Byte 24...25, 44...45, 64...65. Enter
valid values.
Check Bit 4...6 in Byte 6. Enter valid val-
ues.
Check the data record number. Enter a
valid data record number.
Check Bytes 14...33, 34...53, 54...73. En-
ter identical values at all three phases.
Increase the full-scale value or reduce the
transmission ratio of the current and volt-
age transformer.
105