Table of Contents
Advertisement
MAINTENANCE
Cleaning
The recumbent bike can be cleaned with a soft cloth and mild detergent. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the recumbent bike
after each use. Be careful not get excessive moisture on the computer display panel as this
might cause an electrical hazard or electronics to fail.
Please keep the recumbent bike, specially, the computer console, out of direct sunlight to
prevent screen damage.
Please inspect all assembly bolts and pedals on the machine for proper tightness every
week.
Storage
Store the recumbent bike in a clean and dry environment away from children.
TROUBLESHOOTING
PROBLEM
The recumbent bike wobbles when in use. Turn the adjustable leveler on the rear
There is no display on the computer
console.
There is no heart rate reading or heart rate
reading or is erratic / inconsistent.
The recumbent bike makes a squeaking
noise when in use.
SOLUTION
stabilizer as needed to level the recumbent
bike.
1.
Remove the computer console and verify
the wires that come from the computer
console are properly connected to the
wires that come from the front post.
2.
Check if the batteries are correctly
positioned and battery springs are in
proper contact with batteries.
3.
The batteries in the computer console may
be dead. Change to new batteries.
1.
Make sure that the wire connections for
the hand pulse sensors are secure.
2.
To ensure the pulse readout is more
precise, please always hold on to the
handlebar grip sensors with two hands
instead of just with one hand only when
you try to test your heart rate figures.
3.
Gripping the hand pulse sensors too tight.
Try to maintain moderate pressure while
holding onto the hand pulse sensors.
The bolts may be loose on the recumbent bike,
please inspect the bolts and tighten the loose
bolts.
16
Advertisement
Table of Contents
