Table of Contents
Advertisement
Tool:
5
49
8
69
14
Allen Wrench S6
10
30
76
64
Multi Hex Tool with Phillips Screwdriver
6. Rear Handlebar Installation
Attach the Rear Handlebar (8) onto the Back and Seat Support Bracket (5) with two
M8x45mm Bolts (69), two Ø20xØ8x2.0t Washers (14), two Ø16xØ8x1.5t Washers (10), and
two M8 Cap Nuts (30). Tighten cap nuts and bolts with the Multi Hex Tool with Phillips
Screwdriver and S6 Allen Wrench provided.
Connect the Hand Pulse Sensor Extension Wire A (76) from the Rear Main Frame (64) to the
Hand Pulse Sensor Wires (49) from the Rear Handlebar (8).
Hardware:
2 Cap Nuts (M8)
2 Bolts (M8x45mm)
2 Washers
2 Washers
(Ø20xØ8x2.0t)
(Ø16xØ8x1.5t)
11
Advertisement
Table of Contents
